Non-QWERTY keyboards have issues with shortcuts.
-
Hi!
I have the US version of FUZE4, but I'm currently forced to use an AZERTY keyboard (the Switch is set to use the proper keyboard config) and while most of it works nicely, there's at least one shortcut (CTRL-Z) which doesn't work and became CRTL-W (where the Z would be on a QWERTY keyboard, so I thought I'd report it :)
-
Hey there, thanks for the report. So when you type Z and W in the code editor, they correctly produce a Z and a W, but the hotkey is CTRL-W instead of CTRL-Z, is that correct?
I'm unsure of what the expected behavior is for AZERTY keyboards in terms of undo/redo, but I'll discuss it with the team and see if we can figure out what we want to do with it.
-
@Willpowered Hi! Thank you for your reply!
That is correct! The software behaves as if when holding CTRL, it still uses the QWERTY layout for the rest of the keyboard, but when typing normally it works as intended. As far as I know, the shortcuts are the same everywhere (CTRL-Z, X, C, V, etc. )
-
i actually have this problem also with my azerty keyboard and when selecting french (which uses azerty) in the switch locale settings. If i press the W key in the editor it actually types correctly the W character as it should, However the W key sits at the place where Z would be on the qwerty keyboard (W & Z are switch physically on the keyboard). But i intially tought there was no keyboard shortcut for undo as i tried ctrl-z while i later found it ctrl-w worked so it has to do with azerty keyboard (and maybe scancodes) and perhaps keyboard locale settings on the nintendo switch. Now that it know it it's not that big of a problem would have been more of a problem when the editor actually typed Z instead of W :)
